https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6854342#M12105 <P>Are you boing this while a part or assembly is open?</P> <P>If you are, are they in metric units?</P> <P>&nbsp;</P> Sat, 04 Feb 2017 18:03:36 GMT lenny_1962 2017-02-04T18:03:36Z https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6853711#M12104 <P>How do I create a new tool holder in HSM Express using English units? I have done it before in inch units and those are still expressed in inch units in my library, but now it seems to be metric only? When did this change?</P><P>Roger&nbsp;</P> Sat, 04 Feb 2017 01:58:43 GMT https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6853711#M12104 roger 2017-02-04T01:58:43Z https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6854342#M12105 <P>Are you boing this while a part or assembly is open?</P> <P>If you are, are they in metric units?</P> <P>&nbsp;</P> Sat, 04 Feb 2017 18:03:36 GMT https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6854342#M12105 lenny_1962 2017-02-04T18:03:36Z https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6855153#M12106 <P>That is it! When I created the toolholder with no drawing open, it was metric display units only. I just tried it with a drawing open in inch units and the toolhoder can now be created in English units. Thank You!</P><P>Roger</P> Sun, 05 Feb 2017 14:39:46 GMT https://forums.autodesk.com/t5/hsm-support-forum/creating-tool-holder/m-p/6855153#M12106 roger 2017-02-05T14:39:46Z