topic Re: Post Processor for Mazak VCN-570C in HSM Post Processor Forum

Post Processor for Mazak VCN-570C

Anonymous — Thu, 16 Jul 2020 15:44:45 GMT

Hello, We have switched over our CNC machines to Mazak VCN-570C and we are looking into using the Inventor HSM to work with the machines. I'm just learning the program and I was wondering about the post processor that would be best for working with this machine. I did try a program using the generic post processor for the Mazak machine that Autodesk does have but the codes are a little different. Can someone send me in the right direction to modify or if someone know's of a better post processor to use. Thanks in advance

Re: Post Processor for Mazak VCN-570C

will_1 — Fri, 17 Jul 2020 18:46:33 GMT

Hi @Anonymous

Which post did you start with?

The post linked below should be very close to what you need.

https://cam.autodesk.com/hsmposts?p=mazak_vc500

If you do need edits the article below should be helpful.

https://knowledge.autodesk.com/support/autodesk-hsm/learn-explore/caas/sfdcarticles/sfdcarticles/Request-for-post-processors-for-Fusion-360-or-HSM-product.html

Thanks,

Will Watkins

Re: Post Processor for Mazak VCN-570C

Anonymous — Tue, 21 Jul 2020 17:24:51 GMT

Hello Will, Thanks for the information. I did try the one that was with in the inventor program, which was for the Variaxis. I will try the one that you posted to see how it works. Thank again Will

Re: Post Processor for Mazak VCN-570C

c_martinez119599 — Thu, 16 Jan 2025 16:47:04 GMT

Hi will_1,

I am using the Mazak post processor from Autodesk on a Mazak VCN-570c. Everything was working just fine, until it blew out the side of the cylinder it was machining.

I checked the code and I ran the code on three different simulators. I can not find what caused the machine to dig into my part. Below is a section of code where the tool is supposed to do two finishing passes around a .750" cylinder (I attached the first finish pass).

PLEASE ADVISE

N10 T4 M6
S1375 M3
G90 G94 G17
G54
M8
G0 X1.805 Y0.5
G43 Z0.6 H4
G0 Z0.4
G18 G3 X1.305 Z-0.1 I-0.5 K0. F25.
G1 X1.255
G17 G3 X0.755 Y0. I0. J-0.5
G2 X-0.755 I-0.755 J0. F5.5
X0.755 I0.755 J0.
G1 X0.7547 Y-0.0016
X0.7538 Y-0.0029
X0.7525 Y-0.0037
X0.7512 Y-0.0046
X0.7503 Y-0.0059
X0.75 Y-0.0075

Re: Post Processor for Mazak VCN-570C

CNC_Lee — Fri, 17 Jan 2025 22:28:36 GMT

@c_martinez119599

I am happy to take a look at this if you are able to share the Fusion file that caused this error.