https://forums.autodesk.com/t5/hsm-post-processor-forum/mazak-integrex-5-axis-post/m-p/9807769#M6723 <P>i am using generic mazak post processor for I 400 integrex single spindle single turret. i have edited where i get correct indexing but full simultaneous 5 axis doesnt move quite right. also prefer just indexing B C then&nbsp; using just G68 not G68.2. thank you.</P> Fri, 16 Oct 2020 18:25:58 GMT Anonymous 2020-10-16T18:25:58Z https://forums.autodesk.com/t5/hsm-post-processor-forum/mazak-integrex-5-axis-post/m-p/9807769#M6723 <P>i am using generic mazak post processor for I 400 integrex single spindle single turret. i have edited where i get correct indexing but full simultaneous 5 axis doesnt move quite right. also prefer just indexing B C then&nbsp; using just G68 not G68.2. thank you.</P> Fri, 16 Oct 2020 18:25:58 GMT https://forums.autodesk.com/t5/hsm-post-processor-forum/mazak-integrex-5-axis-post/m-p/9807769#M6723 Anonymous 2020-10-16T18:25:58Z https://forums.autodesk.com/t5/hsm-post-processor-forum/mazak-integrex-5-axis-post/m-p/9811263#M6724 <P>Hi&nbsp;@Anonymous&nbsp;,</P> <P>&nbsp;</P> <P>What post processor are you using? It is hard to say what is going wrong with the simultaneous moves without more information. More than likely on a Mazak it is a parameter setting. You can reach out to your Mazak rep for more information on that. I will send you our suggested ones as well.</P> <P>&nbsp;</P> <P>On the G68.2/G68 Mazak recommends that you use G68.2 because there are functions are available in G68.2 that are not available in G68, like G05 P# if I am not mistaken.</P> <P>&nbsp;</P> <P>Thanks,</P> <P>Will</P> Mon, 19 Oct 2020 17:30:48 GMT https://forums.autodesk.com/t5/hsm-post-processor-forum/mazak-integrex-5-axis-post/m-p/9811263#M6724 will_1 2020-10-19T17:30:48Z