https://forums.autodesk.com/t5/hsm-post-processor-forum/post-processor-for-isel-ncp/m-p/6091346#M26182 Hi all, <BR /><BR />I have been meaning to post this back up here for a little while...<BR /><BR />I am running this post processor with no problems on ISEL Flatcom M40, the only small issue is that the program code starts from the datum point at Z0. I manually raise the Z to just above the work piece after setting the datum point.<BR /><BR />The helix plunge does seem to lower quite slowly but no longer hangs in the air for lengthy periods. <BR /><BR />We use the machine as a simple 3D router with no tool changer or coolant so both are disabled in the post.<BR /><BR />I'm no programmer but have modified the post through trial and error and picking up some tips here and there.<BR /><BR />Hope it may help somebody.<BR /><BR />Ben Thu, 15 Oct 2015 09:55:26 GMT Anonymous 2015-10-15T09:55:26Z