topic Tool breakage control post Arumatik in HSM Post Processor Forum

Tool breakage control post Arumatik

info — Fri, 24 Feb 2023 15:23:07 GMT

when I perform the tool breakage check after five-axis machining, it should be performed before removing the G68.2 compensation, so the machine tool does not perform the correct positioning.
attached you see the file

Re: Tool breakage control post Arumatik

BrandonTBFBF — Mon, 27 Feb 2023 12:47:42 GMT

Can you attach the post you're using.

Re: Tool breakage control post Arumatik

info — Mon, 27 Feb 2023 13:00:07 GMT

Hi @BrandonTBFBF ,

I am attaching the post processor

Re: Tool breakage control post Arumatik

BrandonTBFBF — Mon, 27 Feb 2023 17:08:04 GMT

I believe what you need is to have the G325 command after the G69 correct?

If so, try this.

EDIT - Removed File

Re: Tool breakage control post Arumatik

info — Mon, 27 Feb 2023 17:00:04 GMT

Hello @BrandonTBFBF ,
it would be correct to write the g69 first, but I tried writing it with your edited post, but found no change

Re: Tool breakage control post Arumatik

BrandonTBFBF — Mon, 27 Feb 2023 18:08:19 GMT

I forgot you use the Action for tool breakage.

Try this version.

Re: Tool breakage control post Arumatik

info — Mon, 27 Feb 2023 19:50:29 GMT

hi @BrandonTBFBF ,

tested, now everything works perfectly.
Thank you very much!!!