topic Re: Siemens 840D VTL Post Processor in HSM Post Processor Forum

Siemens 840D VTL Post Processor

mattsshop — Thu, 17 Dec 2015 13:36:48 GMT

I was wondering if any one could tell me where to start on a post processor for a VTL machine. We use Mastercam now but want to get away from it. I use HSMworks and Fusion360 but I do 3 axis machines and lathe programming so I am just now learning the VTL. Dose anyone else program for VTL or have any ideas where to start.

Thanks,
Matt

Re: Siemens 840D VTL Post Processor

skidsolo — Thu, 17 Dec 2015 13:44:14 GMT

The place to start depends on the controller of the VTL. If it is a Fanuc you should start with the generic fanuc turning post.

Re: Siemens 840D VTL Post Processor

Laurens-3DTechDraw — Thu, 17 Dec 2015 13:46:50 GMT

AndrewWard wrote:

The place to start depends on the controller of the VTL. If it is a Fanuc you should start with the generic fanuc turning post.

AndrewWard wrote:
The place to start depends on the controller of the VTL. If it is a Fanuc you should start with the generic fanuc turning post.

I think the controller is in the topic name? Siemens 840D

Re: Siemens 840D VTL Post Processor

mattsshop — Thu, 17 Dec 2015 15:11:41 GMT

You are correct, it is a 840D but on a VTL. Is that same as a lathe post turned on upwards?

Re: Siemens 840D VTL Post Processor

Laurens-3DTechDraw — Thu, 17 Dec 2015 15:14:45 GMT

mholtzclaw wrote:

You are correct, it is a 840D but on a VTL. Is that same as a lathe post turned on upwards?

mholtzclaw wrote:
You are correct, it is a 840D but on a VTL. Is that same as a lathe post turned on upwards?

I think the code isn't any different.