Camplete post processor coolant disable, but outputs coolant code

brendenzd — Tue, 18 Apr 2023 18:14:24 GMT

When posting from Fusion 360 using the Camplete post processor a coolant on code is generated when disabled in Fusion. This code is only improperly generated after a tool path with coolant enabled is posted. If you post five tool paths with parameters below, post will generate as shown in Camplete.

Toolpath #1 = Coolant disabled >> Coolant disabled

Toolpath #2 = Coolant enabled >> Coolant enabled

Toolpath #3 = Coolant disabled >> Coolant enabled ***

Toolpath #4 = Coolant enabled >> Coolant enabled

Toolpath #5 = Coolant disabled >> Coolant enabled

As shown above, when posting multiple tool paths the coolant from a previous operation influences the coolant on a later operation. Also, same behavior when posting through the tool setup. While posting individual tool paths it works fine.

topic Camplete post processor coolant disable, but outputs coolant code in HSM Post Processor Forum

Camplete post processor coolant disable, but outputs coolant code