https://forums.autodesk.com/t5/fusion-support-forum/bug-dirty-flag-cleared-on-undo-but-not-redo/m-p/13432929#M995 <P>Repro:</P><P>&nbsp;</P><OL><LI>New file</LI><LI>Create sketch</LI><LI>Draw Rectangle</LI><LI>End sketch</LI><LI>Extrude rectangle</LI><LI>Save</LI><LI>Select top face of cube and extrude again<BR />Project marked as Dirty (*) - CORRECT</LI><LI>Undo<BR />Dirty flag cleared - CORRECT</LI><LI>Undo<BR />Dirty flag set again - CORRECT</LI><LI>Redo<BR />At this point, we are back to where we were on Step 6 (After initial extrude)<BR />Dirty flag not cleared - INCORRECT</LI><LI>Redo then Undo<BR />Dirty flag cleared - CORRECT<BR />We are at the same point as we were in Step 10, and the dirty flag is cleared.<BR />Ergo, the dirty flag is only cleared on an Undo, not on a Redo</LI></OL> Fri, 18 Apr 2025 17:38:03 GMT evilc 2025-04-18T17:38:03Z https://forums.autodesk.com/t5/fusion-support-forum/bug-dirty-flag-cleared-on-undo-but-not-redo/m-p/13432929#M995 <P>Repro:</P><P>&nbsp;</P><OL><LI>New file</LI><LI>Create sketch</LI><LI>Draw Rectangle</LI><LI>End sketch</LI><LI>Extrude rectangle</LI><LI>Save</LI><LI>Select top face of cube and extrude again<BR />Project marked as Dirty (*) - CORRECT</LI><LI>Undo<BR />Dirty flag cleared - CORRECT</LI><LI>Undo<BR />Dirty flag set again - CORRECT</LI><LI>Redo<BR />At this point, we are back to where we were on Step 6 (After initial extrude)<BR />Dirty flag not cleared - INCORRECT</LI><LI>Redo then Undo<BR />Dirty flag cleared - CORRECT<BR />We are at the same point as we were in Step 10, and the dirty flag is cleared.<BR />Ergo, the dirty flag is only cleared on an Undo, not on a Redo</LI></OL> Fri, 18 Apr 2025 17:38:03 GMT https://forums.autodesk.com/t5/fusion-support-forum/bug-dirty-flag-cleared-on-undo-but-not-redo/m-p/13432929#M995 evilc 2025-04-18T17:38:03Z