topic Re: update to 2.0.9512 broke profiles, so can't extrude in Fusion Support Forum

update to 2.0.9512 broke profiles, so can't extrude

DaveGadgeteer — Sat, 19 Dec 2020 20:58:29 GMT

I was forced to update, and now I can't modify a recent design.

Parameters govern dimensions in a sketch and the extrude distance.

The sketch updated with dimensions changes as expected, but the extrude fails when I change that dimension because the profiles are not seen. I added a new circle to the sketch, and it also has no profile.

When I create a new sketch, a circle in it does have a profile and will extrude.

Do I have to start the whole design over, or is there some way to get Fusion to reconsider my sketch? It's fully constrained, with black lines everywhere except on the new circle I added, which has blue but does not act like a profile.

Re: update to 2.0.9512 broke profiles, so can't extrude

TheCADWhisperer — Sat, 19 Dec 2020 21:25:19 GMT

~~Toggle Show Profile.~~

Or maybe it is more than that.

Divide and Conquer.

There is a tiny tiny gap at the black dots.

Delete the Vertical constraint.

Move the angled line up.

Add missing Coincident constraint.

Re: update to 2.0.9512 broke profiles, so can't extrude

jhackney1972 — Sat, 19 Dec 2020 21:17:03 GMT

Your model sketch had an open point as indicated. Corrected model is attached. Make sure you have "Show Profiles" turned on in your sketch panel.