topic Re: Auto rotates and zooms in from start up in Fusion Support Forum

Auto rotates and zooms in from start up

tbarber87 — Mon, 04 Jan 2021 17:08:11 GMT

Hello,

Whenever I start fusion 360, the entire program immediately starts to rotate and zoom out. I'm not sure why it would be doing this. I looked to the forum for answers - tried to adjust certain preference, set orbit points, restart fusion 360 and computer. If someone could help me as soon as possible that would be greatly appreciated!

It should be noted that I used this program prior to leaving for vacation a few weeks ago and did not experience this issue. I came back today and it has continued to do this.

Included is a screencast of the issue

Re: Auto rotates and zooms in from start up

TheCADWhisperer — Mon, 04 Jan 2021 17:24:46 GMT

Are you using a 3DConnexion device?

If so, does the behavior persist if you unplug the device?

If so, I would run Calibrate.

Re: Auto rotates and zooms in from start up

tbarber87 — Mon, 04 Jan 2021 17:38:30 GMT

I am only using a mouse

Re: Auto rotates and zooms in from start up

jhackney1972 — Mon, 04 Jan 2021 17:41:35 GMT

Disconnect your mouse and start or restart Fusion 360 to be sure there is not a stuck button or short in the mouse sending the command. If you have a spare mouse, try it.

Re: Auto rotates and zooms in from start up

tbarber87 — Mon, 04 Jan 2021 17:47:11 GMT

I disconnected my wireless mouse and restarted Fusion 360 with my laptop trackpad (I am using a remote desktop at the moment, again it has worked fine in the past), did not work. I repeated the steps again with a spare hard wired mouse and again did not work.