topic Re: Autorout not available in free version now ? in Fusion Support Forum

Autorout not available in free version now ?

Captain-DJ — Mon, 04 Jan 2021 18:57:01 GMT

Hello and a happy new year !

I made my first PCB in Fusion 360 past some month.

This is only a hobby project and i do nothing last time.

Now i wand to play with this again.

But i see the autoroute function is no more available in the free version ???

Re: Autorout not available in free version now ?

panpan_fan — Wed, 06 Jan 2021 08:47:11 GMT

Hi @Captain-DJ

I hope you are doing well!

For the free version, it has the limitation about the board size. I remember the board size should be 10cm*8cm.

So if the all devices are in the board (10cm*8cm), I think tha AutoRoute should work.

Please check, thanks!

Regards,

Panpan Fan

Re: Autorout not available in free version now ?

jorge_garcia — Wed, 06 Jan 2021 17:47:40 GMT

Hi @Captain-DJ ,

The autorouter is avaliable in the free version of Fusion 360. It's under the Quick route menu, it's not one of the icons immediately visible if you click on the Quick ROute pull down menu you'll see it there.

Just a small clarifcation to Panpan's point, the board size limit is area based so as long as the board has an area smaller than 80cm^2(length x width) you'll be OK.

Let me know if you continue to run into problems.

Best Regards,

Re: Autorout not available in free version now ?

Captain-DJ — Wed, 06 Jan 2021 18:32:49 GMT

Hello.

I can not say wat the problem was.

The message i read was "no autorout in free version and/or some parts not on the pcb"...or similar.

I don´t save the file at this moment, and closed it.

Today i opened the same file from August 2020 and autoroute works and it also works if parts not on the pcb ‌😃‌

Don´t know why i got the message.

Great to hear that here are no new limits from Autodesk !

Thanks for you answere !