topic Re: I use fusion 360 on a mac and I am a beginner in Fusion Support Forum

I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Sat, 13 Feb 2021 21:21:06 GMT

I use fusion 360 on a mac and I am a beginner. When I start a sketch and choose the plane to sketch on the plane dosn't turn to the scetch plane. I have to choose the right view in the top right before i can start drawing. Is there something i can correct this

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Sun, 14 Feb 2021 06:01:08 GMT

That's normal you can click look at in the sketch plate or set in your preferences

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Sun, 14 Feb 2021 09:31:08 GMT

Daniel Lyall thx. That works fine for me

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Sun, 14 Feb 2021 12:31:08 GMT

I do this as well but it doesn’t bother me

Re: I use fusion 360 on a mac and I am a beginner

g-andresen — Tue, 16 Feb 2021 14:46:55 GMT

Hi,

check the settings in your sketch palette

günther

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Tue, 16 Feb 2021 22:01:09 GMT

What would that do?

Re: I use fusion 360 on a mac and I am a beginner

g-andresen — Tue, 16 Feb 2021 22:09:16 GMT

Hi,

This means that when you start the sketch, it automatically switches to the active sketch layer.
However, this setting must be activated in the preferences, which I generally assume.

günther

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Wed, 17 Feb 2021 20:31:11 GMT

Autodesk Community I am fairly new to fusion but learning it and slowly designing some good stuff BUT where are the preferences.... despite extensive searching I just can’t find it. 😳 . A bit weird really. 😀

Re: I use fusion 360 on a mac and I am a beginner

seth.madore — Wed, 17 Feb 2021 21:02:52 GMT

Re: I use fusion 360 on a mac and I am a beginner

FacebookGroupMember — Thu, 18 Feb 2021 09:21:08 GMT

Autodesk Community thx this is the trick I needed

Re: I use fusion 360 on a mac and I am a beginner

g-andresen — Thu, 18 Feb 2021 10:47:19 GMT

Hi,

I'm glad it worked.

Please mark contributions that made a solution by checking them as "Accepted Solution".
This will make it easier for future readers.

günther