https://forums.autodesk.com/t5/fusion-support-forum/fillet-and-shell-need-help-please/m-p/10083019#M90494 <P>Hi, trying to create a bezel for an edge on one of my bodies, It works as intended on one side, <A href="https://i.imgur.com/HQdmnuK.png" target="_blank" rel="noopener">as seen here,</A> but does not work on the opposite edge. I'm not sure why it wouldn't work, and the error message is vague; so any help would be appreciated.</P><P>I'm also trying to hollow out the entire top side of one of the bodies (<A href="https://i.imgur.com/n8uJ6SG.png" target="_blank" rel="noopener">like shown here</A>) but it only allows me to hollow out one section. I'm not sure why it doesn't let me, so I am in need of assistance.</P><P>&nbsp;</P><P>Any help would be appreciated thanks in advance!</P><P>&nbsp;</P> Sun, 14 Feb 2021 23:40:27 GMT Anonymous 2021-02-14T23:40:27Z https://forums.autodesk.com/t5/fusion-support-forum/fillet-and-shell-need-help-please/m-p/10083019#M90494 <P>Hi, trying to create a bezel for an edge on one of my bodies, It works as intended on one side, <A href="https://i.imgur.com/HQdmnuK.png" target="_blank" rel="noopener">as seen here,</A> but does not work on the opposite edge. I'm not sure why it wouldn't work, and the error message is vague; so any help would be appreciated.</P><P>I'm also trying to hollow out the entire top side of one of the bodies (<A href="https://i.imgur.com/n8uJ6SG.png" target="_blank" rel="noopener">like shown here</A>) but it only allows me to hollow out one section. I'm not sure why it doesn't let me, so I am in need of assistance.</P><P>&nbsp;</P><P>Any help would be appreciated thanks in advance!</P><P>&nbsp;</P> Sun, 14 Feb 2021 23:40:27 GMT https://forums.autodesk.com/t5/fusion-support-forum/fillet-and-shell-need-help-please/m-p/10083019#M90494 Anonymous 2021-02-14T23:40:27Z https://forums.autodesk.com/t5/fusion-support-forum/fillet-and-shell-need-help-please/m-p/10084519#M90495 <P>Are there any unresolved issues indicated in your Timeline?</P><P>Are all of your sketches fully defined?</P> Mon, 15 Feb 2021 15:07:07 GMT https://forums.autodesk.com/t5/fusion-support-forum/fillet-and-shell-need-help-please/m-p/10084519#M90495 TheCADWhisperer 2021-02-15T15:07:07Z