https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111901#M89741 <P>I do not receive any error while running your simulation.&nbsp; I am doing it locally.&nbsp; The only suggestion from the simualtion is that your part is over designed for the safety factor.&nbsp; If you receive this error again it usually is because there is modeling error, overlapping bodies or other problem.&nbsp; Model is attached with the completed simulation.</P> <P>&nbsp;</P> <P>&nbsp;</P> Thu, 25 Feb 2021 18:13:12 GMT jhackney1972 2021-02-25T18:13:12Z https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111864#M89740 <P>I am trying to run a simulation but the simulation failed due to a regularisation error. I’m not sure what this means and I was hoping someone could help. I have attached the part below. Thank you.&nbsp;</P> Thu, 25 Feb 2021 18:02:03 GMT https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111864#M89740 Anonymous 2021-02-25T18:02:03Z https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111901#M89741 <P>I do not receive any error while running your simulation.&nbsp; I am doing it locally.&nbsp; The only suggestion from the simualtion is that your part is over designed for the safety factor.&nbsp; If you receive this error again it usually is because there is modeling error, overlapping bodies or other problem.&nbsp; Model is attached with the completed simulation.</P> <P>&nbsp;</P> <P>&nbsp;</P> Thu, 25 Feb 2021 18:13:12 GMT https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111901#M89741 jhackney1972 2021-02-25T18:13:12Z https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111906#M89742 <P>Thank you so much.&nbsp;</P> Thu, 25 Feb 2021 18:14:44 GMT https://forums.autodesk.com/t5/fusion-support-forum/simulation-regularisation-error/m-p/10111906#M89742 Anonymous 2021-02-25T18:14:44Z