topic Re: F360 Engraving Wont Engrave Contour Selection in Fusion Support Forum

F360 Engraving Wont Engrave Contour Selection

bdhowey — Fri, 19 Mar 2021 22:15:07 GMT

The dot is correct the lower section wont engrave the outer profile. Can anyone please help me out with a hint to fix this?

Re: F360 Engraving Wont Engrave Contour Selection

jhackney1972 — Fri, 19 Mar 2021 22:47:29 GMT

Please attach your model so the forum users can take a look at it. To attach your file, open it in Fusion 360, select the File menu, then Export and save it to your hard drive. Then attach in to a forum post using the Attachments section.

Re: F360 Engraving Wont Engrave Contour Selection

bdhowey — Fri, 19 Mar 2021 22:59:38 GMT

Hey thanks for the heads up. I have attached the file.

Re: F360 Engraving Wont Engrave Contour Selection

jhackney1972 — Sat, 20 Mar 2021 00:00:50 GMT

I played with it quite awhile and had no luck. Maybe @seth.madore might be able to give you some ideas.

Re: F360 Engraving Wont Engrave Contour Selection

seth.madore — Sun, 21 Mar 2021 15:20:21 GMT

I'm not having any luck with this. There must be something about the sketch that it's not liking at all. The thing is, it does appear to be fully complete, as we can extrude without issue. I'm sending this up the chain, I've opened up CAM-23890 to investigate.
As a workaround, it MAY be possible to redraw this with less segments (use larger 3-point arcs) and have success

Re: F360 Engraving Wont Engrave Contour Selection

bdhowey — Sun, 21 Mar 2021 21:45:46 GMT

Thank you for putting in the time to check it out.

Re: F360 Engraving Wont Engrave Contour Selection

bdhowey — Sun, 21 Mar 2021 21:49:04 GMT

Thank you for checking this out. I was afraid that ill have to redraw it, not an uncommon problem. It is strange that it press/pulled correctly and appears to be closed properly.

Re: F360 Engraving Wont Engrave Contour Selection

bdhowey — Sun, 04 Apr 2021 20:36:04 GMT

Any luck at figuring out this issue any further?