topic Re: Placement of a copied component based on a configuration parameter in Fusion Support Forum

Placement of a copied component based on a configuration parameter

leoLHPRD — Thu, 07 Nov 2024 19:44:53 GMT

I would like to place a copied component based on a configuration parameter. Is there a way to:

Use a configuration parameter in a copy/move
Attach a copied component to an offset plane (which I know can be set by a configuration parameter

davebYYPCU — Thu, 07 Nov 2024 21:27:17 GMT

Use a configuration parameter in a ~~copy/move~~ Joint
Attach a copied component to an offset plane (which I know can be set by a configuration parameter. - Not possible - Joints use snap points, planes don’t have snap points

Might help….

leoLHPRD — Fri, 08 Nov 2024 14:50:14 GMT

Ok. I get it. Joint is what I should be using w/offset for the snap points and offsets which are configuration parameters, I think.

davebYYPCU — Fri, 08 Nov 2024 17:46:11 GMT

Yep.