topic Re: Surfaces ? in Fusion Support Forum

Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 12:50:20 GMT

Hi , I made a kind of bowl, inside the wall there have to be placed a space for kind of seal. I made the seal, move into the wall and after I cut it out, I can't select the inner profile (which has to be modified), there is always a surface on top? I tried to delete , but I can't. Clearly visible in the section analysis.

Thanks in advance. Jens

Re: Surfaces ?

g-andresen — Sat, 12 Jun 2021 13:44:15 GMT

Hi,

Please share the file.

File > export > save as f3d on local drive > attach it to the next post.

günther

Re: Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 13:46:06 GMT

Sure Günther ....

Re: Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 13:50:28 GMT

I tried to upload this picture as well, it failed. This shows how one surface is blocking me to modify parts of the rings.

Re: Surfaces ?

g-andresen — Sat, 12 Jun 2021 14:52:14 GMT

Hi,

the ring wasn´t in a correct position.

I used MOVE > point to point

Screencast

günther

Re: Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 14:54:09 GMT

Hi Günther, Thank you very much, I will try. Did you check if you can now select only the inner ring as attached to modify?

Re: Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 14:55:50 GMT

Yes Günther its working, thanks again and nice weekend!!

Re: Surfaces ?

g-andresen — Sat, 12 Jun 2021 15:08:37 GMT

Hi,

@jsLZWXV wrote:
Yes Günther its working, thanks again and nice weekend!!

thank you, same for you.

I recommend: Put such profiles in place from the beginning.

Screencast

günther

Re: Surfaces ?

jsLZWXV — Sat, 12 Jun 2021 15:23:18 GMT

Good advise !!! Thanks Günther .

Re: Surfaces ?

g-andresen — Sat, 12 Jun 2021 20:57:26 GMT

Hi,

Please mark contributions that made a solution by checking them as "Accepted Solution".
This will make it easier for future readers.

günther