https://forums.autodesk.com/t5/fusion-support-forum/unable-to-sweep-fillet-along-tight-path/m-p/10401626#M79284 <P>I am trying to do a fillet or sweep along a fairly tight path which is giving me errors due to intersecting surfaces. I'm not sure what other way I could achieve the part I need without using a sweep or a fillet. I also attempted using a surface sweep, which didn't return an error but gave me surface artifacts from the intersecting profile. Attached is a picture of this for reference of what I'm trying to achieve.</P> Fri, 18 Jun 2021 15:13:38 GMT mbrady4597 2021-06-18T15:13:38Z https://forums.autodesk.com/t5/fusion-support-forum/unable-to-sweep-fillet-along-tight-path/m-p/10401626#M79284 <P>I am trying to do a fillet or sweep along a fairly tight path which is giving me errors due to intersecting surfaces. I'm not sure what other way I could achieve the part I need without using a sweep or a fillet. I also attempted using a surface sweep, which didn't return an error but gave me surface artifacts from the intersecting profile. Attached is a picture of this for reference of what I'm trying to achieve.</P> Fri, 18 Jun 2021 15:13:38 GMT https://forums.autodesk.com/t5/fusion-support-forum/unable-to-sweep-fillet-along-tight-path/m-p/10401626#M79284 mbrady4597 2021-06-18T15:13:38Z https://forums.autodesk.com/t5/fusion-support-forum/unable-to-sweep-fillet-along-tight-path/m-p/10401700#M79285 <P>yes, this is a limitation of Sweep - it does not allow self-intersecting results.&nbsp; And, yes, surface Sweep can allow this step to succeed, but the result is still somewhat invalid geometry.&nbsp; There may be other ways to get to the final result, though.</P> Fri, 18 Jun 2021 15:40:26 GMT https://forums.autodesk.com/t5/fusion-support-forum/unable-to-sweep-fillet-along-tight-path/m-p/10401700#M79285 jeff_strater 2021-06-18T15:40:26Z