modal analysis of simple cantilever beam

urish111 — Mon, 05 Jul 2021 08:16:07 GMT

Hi,

A modal analysis of a simple case of a 12x5mm length 70mm stainless cantilever beam, that I am willing to perform as my bench mark for the modal analysis quality of fusion frequency simulation I get a big gap between hand calculations and experience and what I get from the simulation.

I tried different styles of mesh and played with some different parameters there is in fusion but it did not have any significant effect and I always get the same fat from calculation answer of 1st mode around 850hz.

where in reality we should be getting something around 270Hz.

thanks,

Uri

Re: modal analysis of simple cantilever beam

TheCADWhisperer — Mon, 05 Jul 2021 12:06:10 GMT

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

Also, can you show image of your hand calcs?

topic Re: modal analysis of simple cantilever beam in Fusion Support Forum

modal analysis of simple cantilever beam

Re: modal analysis of simple cantilever beam