topic Re: Generated toolpath different depending on the WCS reference point in Fusion Support Forum

Generated toolpath different depending on the WCS reference point

regis.priqueler — Fri, 30 Jul 2021 15:47:40 GMT

Hi,

I got a 2D adaptive on a setup where WCS origin is position in the top middle of the stock. And it generates as intended. But fi I change the position of the origin to the middle bottom of the stock it generates differently and the result doesn't make sense.

I duplicate the first toolpath to be sure they have the same settings.

Middle top

then middle bottom

Re: Generated toolpath different depending on the WCS reference point

seth.madore — Fri, 30 Jul 2021 18:19:07 GMT

Well, that's not supposed to happen. However, I have started to see a lot of 2d issues flowing back to WCS location as the cause.

Could you share your file?
File > Export > Save to local folder, return to thread and attach the .f3d file in your reply

Re: Generated toolpath different depending on the WCS reference point

regis.priqueler — Fri, 30 Jul 2021 20:35:46 GMT

Hi, Thanks for your answer, here's the file