topic Sketch dimension alters unrelated slot geometry. in Fusion Support Forum

Sketch dimension alters unrelated slot geometry.

AidenSG — Mon, 15 Nov 2021 07:46:50 GMT

Hello there,

Just wanted to report a minor bug I found today.

By changing the 367.913mm dimension, in Sketch2, to 350mm it will cause the right-hand slot to become over 3.6m in length and extremely narrow.

File is attached.

Re: Sketch dimension alters unrelated slot geometry.

davebYYPCU — Mon, 15 Nov 2021 08:38:50 GMT

Blue sketch geometry is unstable. The behaviour is unusual but ...

Your sketch needs more constraint / dimensions, before you can expect stable results.

Fully constrained - there is no bug.

Might help....

Betreff: Sketch dimension alters unrelated slot geometry.

g-andresen — Mon, 15 Nov 2021 10:06:15 GMT

Hi,

look at what @davebYYPCU is talking about.

günther

Re: Sketch dimension alters unrelated slot geometry.

AidenSG — Mon, 15 Nov 2021 11:26:34 GMT

This occured after roughly sketching the slots and as I was mid-way through defining everything. However it's the first time I've encountered this quirk while doing so.

Dragging the slot around and then trying to apply the dimension worked without altering the slot dimensions.

Just wanted to report this unusual behaviour in case it was something doing something it shouldn't.

Not looking for solutions but thank you for the responses.