topic Pocket issue - different sizes IRL to fusion drawing in Fusion Support Forum

Pocket issue - different sizes IRL to fusion drawing

rebecca.shillito — Wed, 17 Nov 2021 20:12:08 GMT

Evening

I have been making some quick jigs up in Fusion, making use of the Nifty Slicer to expedite the process.

Please see the attached file.

The issue I am facing is that the milled pockets are about .5mm smaller on each edge than the drawing.

All other dimensions are as they should be.

I'm thinking this is the pocketing strategy that I am using but can't work it out.

Any help would be greatly appreciated.

Thank you all in advance!

HughesTooling — Thu, 18 Nov 2021 09:21:01 GMT

Could be defection depending on how ridgid you setup is. Try enabling finish cuts with a 0.1mm for the last cut.

rebecca.shillito — Sat, 20 Nov 2021 15:56:11 GMT

Brilliant, thank you that worked a treat!