https://forums.autodesk.com/t5/fusion-support-forum/changing-the-axis-of-projected-geometry/m-p/10837392#M66550 <P>There are a few ways to get the outcome.</P> <P>Quickest is to extend / duplicate the original body and use Sketch &gt; Project Intersect this extension where it passes the current sketch plane.</P> <P>&nbsp;</P> <P>Similar but different is to Project to Surface on destination sketch plane with Vector assignment.</P> <P>Both require a dummy body.</P> <P>&nbsp;</P> <P>Might help.....</P> Wed, 22 Dec 2021 07:24:13 GMT davebYYPCU 2021-12-22T07:24:13Z https://forums.autodesk.com/t5/fusion-support-forum/changing-the-axis-of-projected-geometry/m-p/10837376#M66549 <P>By default, when the geometry is projected, the geometry projects following the axis perpendicular to the sketch plane. Is there a way to change this so that it uses another axis to project? The attached screenshot demonstrates typical behavior. In my situation, I would like to project long the origin axis of the "steel" part rather than the current sketch planes origin axis.</P> Wed, 22 Dec 2021 07:06:30 GMT https://forums.autodesk.com/t5/fusion-support-forum/changing-the-axis-of-projected-geometry/m-p/10837376#M66549 Anonymous 2021-12-22T07:06:30Z https://forums.autodesk.com/t5/fusion-support-forum/changing-the-axis-of-projected-geometry/m-p/10837392#M66550 <P>There are a few ways to get the outcome.</P> <P>Quickest is to extend / duplicate the original body and use Sketch &gt; Project Intersect this extension where it passes the current sketch plane.</P> <P>&nbsp;</P> <P>Similar but different is to Project to Surface on destination sketch plane with Vector assignment.</P> <P>Both require a dummy body.</P> <P>&nbsp;</P> <P>Might help.....</P> Wed, 22 Dec 2021 07:24:13 GMT https://forums.autodesk.com/t5/fusion-support-forum/changing-the-axis-of-projected-geometry/m-p/10837392#M66550 davebYYPCU 2021-12-22T07:24:13Z