topic Re: Face not extruding all the way in Fusion Support Forum

Face not extruding all the way

navpat — Fri, 07 Jan 2022 22:28:38 GMT

Hi all,

I'm trying to extrude a face (by pressing q and e) 18mm outward but it only goes to 10 mm. The face turns red after that. I tried making another circle and tried extruding that further but it only goes to 10 mm too. Any suggestions?

Please take a look at my screen below:

Re: Face not extruding all the way

jhackney1972 — Fri, 07 Jan 2022 23:02:45 GMT

Look in your Browser, notice you have an Analysis folder containing a, maybe more, Sectional Analysis. Open it and turn off the active sectional analysis and it will work fine.

Re: Face not extruding all the way

jeff_strater — Fri, 07 Jan 2022 23:03:14 GMT

you have a Section Analysis enabled on this design. The Extrude is fine, it is just extending beyond the cutting plane of the section. Turn off the analysis, and you will see that your geometry is fine.

Re: Face not extruding all the way

navpat — Fri, 07 Jan 2022 23:08:37 GMT

yes, it worked! thank you

Re: Face not extruding all the way

navpat — Fri, 07 Jan 2022 23:08:55 GMT

it worked, thank you!