https://forums.autodesk.com/t5/fusion-support-forum/lift-design-help/m-p/10896200#M64789 <P>Hi, having some problems with a lift design. It involves the rotation of two powerscrews through a gear system, which should convert rotational movement to the lateral (up/down) movement of the lift. However, the motion link between the slider joint of the lift and revolute joint of the gears causes the lift to spin around. I have attached some pictures if it helps. I am quite new to fusion, so my mistake may be obvious. Any help would be much appreciated:)</P> Fri, 21 Jan 2022 13:34:21 GMT bar20001566 2022-01-21T13:34:21Z https://forums.autodesk.com/t5/fusion-support-forum/lift-design-help/m-p/10896200#M64789 <P>Hi, having some problems with a lift design. It involves the rotation of two powerscrews through a gear system, which should convert rotational movement to the lateral (up/down) movement of the lift. However, the motion link between the slider joint of the lift and revolute joint of the gears causes the lift to spin around. I have attached some pictures if it helps. I am quite new to fusion, so my mistake may be obvious. Any help would be much appreciated:)</P> Fri, 21 Jan 2022 13:34:21 GMT https://forums.autodesk.com/t5/fusion-support-forum/lift-design-help/m-p/10896200#M64789 bar20001566 2022-01-21T13:34:21Z https://forums.autodesk.com/t5/fusion-support-forum/lift-design-help/m-p/10896323#M64790 <P>Hi,</P><P><A href="https://forums.autodesk.com/t5/fusion-360-design-validate/lift-design-help/td-p/10896245" target="_blank" rel="noopener">double post</A></P><P>&nbsp;</P><P>günther</P> Fri, 21 Jan 2022 14:18:44 GMT https://forums.autodesk.com/t5/fusion-support-forum/lift-design-help/m-p/10896323#M64790 g-andresen 2022-01-21T14:18:44Z