https://forums.autodesk.com/t5/fusion-support-forum/bug-cursor-stops-durcing-creation-of-a-slot-when-getting-to/m-p/10899266#M64653 <P>If I try to create any Kind of Slot in Sketch view, my Cursor suddenly stop when I get to close to 0 on the X-Axis, and only "reawakens" when I move away from 0 again. Zooming in or out seems to change the Distance to 0 at which this behaviour appears and even might remedy it.</P> Sun, 23 Jan 2022 12:21:44 GMT Centro93 2022-01-23T12:21:44Z https://forums.autodesk.com/t5/fusion-support-forum/bug-cursor-stops-durcing-creation-of-a-slot-when-getting-to/m-p/10899266#M64653 <P>If I try to create any Kind of Slot in Sketch view, my Cursor suddenly stop when I get to close to 0 on the X-Axis, and only "reawakens" when I move away from 0 again. Zooming in or out seems to change the Distance to 0 at which this behaviour appears and even might remedy it.</P> Sun, 23 Jan 2022 12:21:44 GMT https://forums.autodesk.com/t5/fusion-support-forum/bug-cursor-stops-durcing-creation-of-a-slot-when-getting-to/m-p/10899266#M64653 Centro93 2022-01-23T12:21:44Z https://forums.autodesk.com/t5/fusion-support-forum/bug-cursor-stops-durcing-creation-of-a-slot-when-getting-to/m-p/10899689#M64654 <P>yes, this is intended behavior.&nbsp; There is always a point at 0,0 in the sketch, and Fusion will snap to vertical and horizontal alignment with that point.&nbsp; The snap range is set so that you do not have to be precise to align with this point.&nbsp; And, yes, zooming in will change that snap tolerance.&nbsp; You can suppress this by holding down CTRL (CMD on Mac), which will suppress all snapping/inferencing.</P> <P>&nbsp;</P> Sun, 23 Jan 2022 17:27:16 GMT https://forums.autodesk.com/t5/fusion-support-forum/bug-cursor-stops-durcing-creation-of-a-slot-when-getting-to/m-p/10899689#M64654 jeff_strater 2022-01-23T17:27:16Z