https://forums.autodesk.com/t5/fusion-support-forum/nesting-problem/m-p/11002761#M60728 <P>Hello,</P><P>&nbsp;</P><P>I am looking for some guidance. I have designed a new way I want to make an upper cabinet. I am having an issue with nesting in in Vcarve pro from Fusion 360. The specific problem is nesting the back panel as it seem to not work. It ends up breaking up the panel into pieces. I have isolated it to the tbone fillets that I added to the back dado, but cannot figure out home to get it to nest with the rest of the cabinet parts. I can only get it to nest if I remove the fillets. I am using mapboard pro. I anyone has any insight, I would greatly appreciate it. I am sure it is user error.&nbsp;</P><P>&nbsp;</P><P>Please see attached link&nbsp;&nbsp;</P><P>&nbsp;</P><P>Thank you.&nbsp;</P> Mon, 14 Mar 2022 06:00:13 GMT jgolob21 2022-03-14T06:00:13Z https://forums.autodesk.com/t5/fusion-support-forum/nesting-problem/m-p/11002761#M60728 <P>Hello,</P><P>&nbsp;</P><P>I am looking for some guidance. I have designed a new way I want to make an upper cabinet. I am having an issue with nesting in in Vcarve pro from Fusion 360. The specific problem is nesting the back panel as it seem to not work. It ends up breaking up the panel into pieces. I have isolated it to the tbone fillets that I added to the back dado, but cannot figure out home to get it to nest with the rest of the cabinet parts. I can only get it to nest if I remove the fillets. I am using mapboard pro. I anyone has any insight, I would greatly appreciate it. I am sure it is user error.&nbsp;</P><P>&nbsp;</P><P>Please see attached link&nbsp;&nbsp;</P><P>&nbsp;</P><P>Thank you.&nbsp;</P> Mon, 14 Mar 2022 06:00:13 GMT https://forums.autodesk.com/t5/fusion-support-forum/nesting-problem/m-p/11002761#M60728 jgolob21 2022-03-14T06:00:13Z