topic Overconstrain bug I think in Fusion Support Forum

Overconstrain bug I think

kiklhorn — Sat, 21 May 2022 14:04:25 GMT

I think found an overconstrain error.

Re: Overconstrain bug I think

HughesTooling — Sat, 21 May 2022 14:17:25 GMT

I think the problem is because you're dimensioning off an offset. If you try adding the dimension to the outer rectangle there's no problem. Also works if you use endpoints rather than selecting lines.

Here I've selected the end points.

Re: Overconstrain bug I think

HughesTooling — Sat, 21 May 2022 14:22:14 GMT

By the way I don't think this is a bug because you're not allowed to use an offset to drive the source curves.

In the simple example below you are not allowed to dimension the inner offset rectangle to drive the source outer rectangle. If anything the workarond I gave you above is a bug that shouldn't work, @jeff_strater what do you think?