topic Re: Endless loop on the Fusion loadind (new version) in Fusion Support Forum

Endless loop on the Fusion loading (new version)

Hrvoje- — Wed, 06 Jul 2022 16:05:19 GMT

When I start the program (Fusion 360) I fall into an endless loop. I attached 3 screen captures of the error message. Also, I included two diagnostic files.

How to resolve this problem?

Thank you for the help!

Re: Endless loop on the Fusion loadind (new version)

HelenChen-AutodeskQA — Wed, 06 Jul 2022 01:28:07 GMT

Hi @Hrvoje- ,

Sorry for any inconvenience.

May I know the Fusion version you are using now? We have an issue about this in Mar release, but it should have no such issue for new Fusion version now.

We have a solution provided in link below which could help you:

https://knowledge.autodesk.com/support/fusion-360/troubleshooting/caas/sfdcarticles/sfdcarticles/Fusion-360-fails-to-fully-launch-and-gives-the-error-Fusion-360--DB-error-no-such-table-main-Technologies.html

Could you please following the instructions to delete corresponded DB file and then relaunch Fusion? Suppose it should work after that.

Hope it helps. Thanks.

Best regards,

Helen

Re: Endless loop on the Fusion loadind (new version)

Hrvoje- — Wed, 06 Jul 2022 06:24:17 GMT

Thank you, Helen, it helped!

This is the version of the program I am using.

Re: Endless loop on the Fusion loadind (new version)

HelenChen-AutodeskQA — Wed, 06 Jul 2022 08:04:58 GMT

Thank you very much for your update @Hrvoje- .

So sorry for any inconvenience about this.

Best regards,

Helen

Re: Endless loop on the Fusion loadind (new version)

Hrvoje- — Wed, 06 Jul 2022 14:43:07 GMT

It is OK, Helen! There where no inconvenience on my side. I am a retired, ship model hobbyist, and I use Fusion as a nice distraction. No money loss at all! 🙂