topic Point Probe Not working in Fusion Support Forum

Point Probe Not working

colinhun — Sat, 16 Jul 2022 00:25:11 GMT

For some reason, Point probes don't seem to give me any information in the table view after running a simulation. I still get Min/Max information. I can see the probes work when I move the slider and look at the model but I don't see the information when I look at the curve or table charts.

Re: Point Probe Not working

jhackney1972 — Sat, 16 Jul 2022 00:52:04 GMT

Take a look at the Screencast for a very simple beam analysis and placement of Point Probes.

Re: Point Probe Not working

jhackney1972 — Sat, 16 Jul 2022 01:04:12 GMT

I may have misunderstood your question. You did not want to see how to show Probes on the model, you were looking for them in the Result Report. I apologize, I do not see them in the final report either.

Re: Point Probe Not working

jhackney1972 — Sat, 16 Jul 2022 01:19:33 GMT

I found them in the report. If you have checked "Show Probes", you will see them in the graphic diagram, not in a table, in your report. You will have to change the graphic display, at the beginning or end of the report to see them.

Re: Point Probe Not working

colinhun — Sat, 16 Jul 2022 03:06:42 GMT

I could see the probe point in the report but I'm specifically looking for the table with values of that probe so I can plot a load-displacement curve using reaction force (z) and Displacement (z). In the report, I only get the curve, not the data.

I'll insert a screenshot showing what I mean, there's only the chart, not the table of data.