topic Re: Flat pattern in Fusion Support Forum

Flat pattern

jonas.holmstedt — Fri, 12 Aug 2022 04:39:57 GMT

Hi,

How can i make this to a flat pattern?

davebYYPCU — Fri, 12 Aug 2022 07:12:21 GMT

Is it Sheet Matal part?

Needs to have edges perpendicular to faces.

Might help....

jonas.holmstedt — Fri, 12 Aug 2022 07:37:22 GMT

It`s a body and i cant convert it to sheetmetal.

davebYYPCU — Fri, 12 Aug 2022 08:48:11 GMT

Yep, looks like it was made with Loft.

If not converting, will be the non square edge (right side of pic) or not constant thickness, holding you back.

Might help....

g-andresen — Fri, 12 Aug 2022 08:52:52 GMT

Hi,

you need a flat face

günther

TheCADWhisperer — Fri, 12 Aug 2022 10:58:39 GMT

@jonas.holmstedt wrote:
Hi,
How can i make this to a flat pattern?

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

jonas.holmstedt — Fri, 12 Aug 2022 11:49:05 GMT

jonas.holmstedt — Fri, 12 Aug 2022 11:51:07 GMT

g-andresen — Fri, 12 Aug 2022 12:48:40 GMT

Hi,

1. for conversion into sheet metal part, the thickness of the component must be constant. This is not the case here.

2. in addition, there must be a flat surface for unfolding, which can be added additively perpendicular to a flat edge.

günther

TheCADWhisperer — Fri, 12 Aug 2022 16:25:53 GMT

Why do you have Capture Design History turned off?

Turn history back on

remodel the part from scratch with history and then re-attach the new attempt here.