https://forums.autodesk.com/t5/fusion-support-forum/unable-to-change-units-in-a-part-drawing/m-p/11433825#M50092 <P>Recently I made a custom title block to update a large amount of part drawings. These part drawings were created with inches as the units. The goal is to convert them to metric. The title block was created with MM as the standard. I now realize that you cannot mix dimensions so I wanted to change the dimensions on the title block to inches. However, when I update the document properties to be in inches instead of metric, I am still not able to add a new sheet to implement the title block. I noticed it seems fusion 360 is using the read only units when trying to add a new sheet. Is it not possible to change the units on the title block / drawing sheet or is this a bug?</P> Tue, 20 Sep 2022 15:19:18 GMT corgan.davis 2022-09-20T15:19:18Z https://forums.autodesk.com/t5/fusion-support-forum/unable-to-change-units-in-a-part-drawing/m-p/11433825#M50092 <P>Recently I made a custom title block to update a large amount of part drawings. These part drawings were created with inches as the units. The goal is to convert them to metric. The title block was created with MM as the standard. I now realize that you cannot mix dimensions so I wanted to change the dimensions on the title block to inches. However, when I update the document properties to be in inches instead of metric, I am still not able to add a new sheet to implement the title block. I noticed it seems fusion 360 is using the read only units when trying to add a new sheet. Is it not possible to change the units on the title block / drawing sheet or is this a bug?</P> Tue, 20 Sep 2022 15:19:18 GMT https://forums.autodesk.com/t5/fusion-support-forum/unable-to-change-units-in-a-part-drawing/m-p/11433825#M50092 corgan.davis 2022-09-20T15:19:18Z https://forums.autodesk.com/t5/fusion-support-forum/unable-to-change-units-in-a-part-drawing/m-p/11433853#M50093 <P>UPDATE: Incase anyone else has this issue, if you auto select your title block even if all the units are the same it will error out. You must select it via the browse function, not the drop down.&nbsp;</P> Tue, 20 Sep 2022 15:35:05 GMT https://forums.autodesk.com/t5/fusion-support-forum/unable-to-change-units-in-a-part-drawing/m-p/11433853#M50093 corgan.davis 2022-09-20T15:35:05Z