https://forums.autodesk.com/t5/fusion-support-forum/fusion-360-using-last-command-again/m-p/11491625#M48762 <P>When sketching a line the rule is that the line continues, from point to point, until you either click on an existing sketch object or you select the circle with a check in it. &nbsp;If you want to repeat a command by right clicking and selecting the Repeat Line or whatever command you just executed. &nbsp;One advantage to using the circle with the check is it stops the current line but keeps you in the line command.</P> Tue, 18 Oct 2022 20:04:36 GMT jhackney1972 2022-10-18T20:04:36Z https://forums.autodesk.com/t5/fusion-support-forum/fusion-360-using-last-command-again/m-p/11491535#M48761 <P>when drawing a line sometimes I can keep using the line command after clicking and sometimes I can't. I believe that there are some keystrokes that will allow me to reuse the last command.&nbsp;</P> Tue, 18 Oct 2022 19:24:42 GMT https://forums.autodesk.com/t5/fusion-support-forum/fusion-360-using-last-command-again/m-p/11491535#M48761 dan.bedore 2022-10-18T19:24:42Z https://forums.autodesk.com/t5/fusion-support-forum/fusion-360-using-last-command-again/m-p/11491625#M48762 <P>When sketching a line the rule is that the line continues, from point to point, until you either click on an existing sketch object or you select the circle with a check in it. &nbsp;If you want to repeat a command by right clicking and selecting the Repeat Line or whatever command you just executed. &nbsp;One advantage to using the circle with the check is it stops the current line but keeps you in the line command.</P> Tue, 18 Oct 2022 20:04:36 GMT https://forums.autodesk.com/t5/fusion-support-forum/fusion-360-using-last-command-again/m-p/11491625#M48762 jhackney1972 2022-10-18T20:04:36Z