https://forums.autodesk.com/t5/fusion-support-forum/gcode-generated-by-fusion-360-for-grbl-sending-error-33-on-g3/m-p/11678649#M44013 <P>Trying to do a rather detailed 3D lion face.&nbsp; After generating the GCODE using fusion 360 and GRBL post it runs fine in simulator mode but I get this error when running it in check mode on UGS.</P><P>{Error} An error was detected while sending 'G3X1.546Y-0.4092Z-0.9575I-0.011J-0.0006'</P><P>It did check OK on a number of previous G3 commands.</P><P>What am I doing wrong?</P><P>Thanks</P> Sat, 14 Jan 2023 00:50:15 GMT tkms002 2023-01-14T00:50:15Z https://forums.autodesk.com/t5/fusion-support-forum/gcode-generated-by-fusion-360-for-grbl-sending-error-33-on-g3/m-p/11678649#M44013 <P>Trying to do a rather detailed 3D lion face.&nbsp; After generating the GCODE using fusion 360 and GRBL post it runs fine in simulator mode but I get this error when running it in check mode on UGS.</P><P>{Error} An error was detected while sending 'G3X1.546Y-0.4092Z-0.9575I-0.011J-0.0006'</P><P>It did check OK on a number of previous G3 commands.</P><P>What am I doing wrong?</P><P>Thanks</P> Sat, 14 Jan 2023 00:50:15 GMT https://forums.autodesk.com/t5/fusion-support-forum/gcode-generated-by-fusion-360-for-grbl-sending-error-33-on-g3/m-p/11678649#M44013 tkms002 2023-01-14T00:50:15Z https://forums.autodesk.com/t5/fusion-support-forum/gcode-generated-by-fusion-360-for-grbl-sending-error-33-on-g3/m-p/11681057#M44014 <P>Looks like the solution to your problem may be given by&nbsp;<a href="https://forums.autodesk.com/t5/user/viewprofilepage/user-id/4354750">@AmandaFowler</a>&nbsp;<A href="https://forums.autodesk.com/t5/fusion-360-support/invalid-gcode-id-33/m-p/7768454" target="_blank" rel="noopener">here</A>.</P> Sun, 15 Jan 2023 20:56:21 GMT https://forums.autodesk.com/t5/fusion-support-forum/gcode-generated-by-fusion-360-for-grbl-sending-error-33-on-g3/m-p/11681057#M44014 ltomuta 2023-01-15T20:56:21Z