https://forums.autodesk.com/t5/fusion-support-forum/siemens-nx-control-scheme/m-p/11828490#M40351 <P>&nbsp;My preference is to use a 3DConnexion device for primary navigation rather than mouse.</P> Fri, 17 Mar 2023 12:47:57 GMT TheCADWhisperer 2023-03-17T12:47:57Z https://forums.autodesk.com/t5/fusion-support-forum/siemens-nx-control-scheme/m-p/11827574#M40350 <P>I switch back and forth between Fusion (for personal use) and NX (for work), and I cannot figure out how to get the controls for pan, zoom and orbit to match between the two. It kills me when I come home and open fusion, only to wildly flip my model around trying to pan.<BR /><BR />NX gives you no customization whatsoever, and fusion has various options, but none of them get me all the way there. It appears that powermill gets me pretty close but the wonky orbit, with no ability to change back to the fusion default, makes it unsuitable.<BR /><BR />I was hoping someone could point me to something I had missed in fusion (or NX, if you happen to have experience) to make the controls match.<BR /><BR />NX defaults are middle click for orbit and shift+middle click for pan.</P> Fri, 17 Mar 2023 02:47:44 GMT https://forums.autodesk.com/t5/fusion-support-forum/siemens-nx-control-scheme/m-p/11827574#M40350 Bupher 2023-03-17T02:47:44Z https://forums.autodesk.com/t5/fusion-support-forum/siemens-nx-control-scheme/m-p/11828490#M40351 <P>&nbsp;My preference is to use a 3DConnexion device for primary navigation rather than mouse.</P> Fri, 17 Mar 2023 12:47:57 GMT https://forums.autodesk.com/t5/fusion-support-forum/siemens-nx-control-scheme/m-p/11828490#M40351 TheCADWhisperer 2023-03-17T12:47:57Z