topic Re: Unable to find result selector in Static Simulation in Fusion Support Forum

Unable to find result selector in Static Simulation

regerohan07 — Sat, 15 Apr 2023 14:15:20 GMT

Hello,

I just did a simple static simulation but cannot switch between results. is the result selector missing, or has it been moved elsewhere?

It is only showing the safety factor. How Do I change it?

Re: Unable to find result selector in Static Simulation

TheCADWhisperer — Sat, 15 Apr 2023 16:59:55 GMT

@regerohan07

Does this behavior persists if you reboot the computer?

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

What graphics card are you running?

Re: Unable to find result selector in Static Simulation

regerohan07 — Sat, 15 Apr 2023 17:31:30 GMT

Hey, @TheCADWhisperer Thank you for your suggestion. I tried restarting Fusion and even rebooting the PC. Still no luck. I've attached the F3D file below.

I'm running 3050Ti Mobile

Re: Unable to find result selector in Static Simulation

jhackney1972 — Sat, 15 Apr 2023 17:47:32 GMT

Your posted picture is a little too low to show the menu. There is a drop-down menu as shown by the screen capture below. This of course is after the study has be completed.

Re: Unable to find result selector in Static Simulation

regerohan07 — Sat, 15 Apr 2023 17:49:25 GMT

Hello @jhackney1972 it is not available in my setup

Re: Unable to find result selector in Static Simulation

jhackney1972 — Sat, 15 Apr 2023 17:59:03 GMT

I do not know what to tell you. I am showing the result selection for your model on a Windows computer running a standard subscription Fusion 360 license. I do notice your have a Yellow warning showing on your Results icon in the Browser, maybe you just need to re-calculate your results?

Re: Unable to find result selector in Static Simulation

regerohan07 — Sat, 15 Apr 2023 18:17:37 GMT

I tried that, but it still doesn't show the selection