topic Re: trouble with lofting 3 profiles in Fusion Support Forum

trouble with lofting 3 profiles

syd.patterson — Sat, 01 Jul 2023 17:44:22 GMT

hello all,

trying to figure out how to use include 3d geometry to connect the rails on these 3 profiles in order to blend them all together, any advice would be appreciated, maybe I just don't have all the numbers defined properly.

Re: trouble with lofting 3 profiles

TheCADWhisperer — Sat, 01 Jul 2023 18:12:49 GMT

@syd.patterson

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

Are all of your sketches fully defined?

Are there any unresolved issues highlighted in your Timeline?

Do you have a picture of something similar that already exists in the real world?

I suspect that you will need a Surface Patch.

Re: trouble with lofting 3 profiles

syd.patterson — Sat, 01 Jul 2023 19:04:30 GMT

ive tried to attach it below and redo my steps

Re: trouble with lofting 3 profiles

syd.patterson — Sat, 01 Jul 2023 21:36:47 GMT

he is another image of the issue

Re: trouble with lofting 3 profiles

TheCADWhisperer — Sun, 02 Jul 2023 10:12:27 GMT

I didn't take the time to match the bottom side - but I think you can figure out the rest.

Post back if you run into trouble...

You've come a long ways.

I think this could be simplified and also you might want to experiment with Tangent Weight...

@syd.patterson

I made some revisions...