topic Re: .step file image does not rotate in Fusion Support Forum

.step file image does not rotate

vgershma — Mon, 20 Nov 2023 19:07:07 GMT

I exported a PCB file from KiCad software as .step file. Then inserted the .step file into my existing Fusion 360 design. I'd like to rotate the .step image or it projection, but neither works. When i right click and select rotate angle, the OK box stays greyed out.

Any suggestions please?

thanks

Re: .step file image does not rotate

jhackney1972 — Mon, 20 Nov 2023 19:04:02 GMT

Please attach the STEP File.

Re: .step file image does not rotate

vgershma — Mon, 20 Nov 2023 19:20:46 GMT

just attached the file. thanks

Re: .step file image does not rotate

jhackney1972 — Mon, 20 Nov 2023 19:28:30 GMT

I do not see an issue with any type of rotate or move. I attached my Fusion 360 .F3D file, open it and see if you still see the issue. If you do not, you are not opening it correctly, if you do, then I would be a suspect of your Fusion 360 installation.

Re: .step file image does not rotate

jhackney1972 — Mon, 20 Nov 2023 19:36:20 GMT

Sometimes when using the Free Move Type and you select Set Pivot, you forget the Set Pivot icon is a toggle and must be selected again AFTER you select the desired Pivot point.