topic Re: Creating a surface in Fusion Support Forum

Creating a surface

dsj013 — Thu, 25 Jan 2024 22:01:35 GMT

Hi,

I have two curved lines and I am wanting to make a surface between them where the surface follows the curve paths. There is a feature on Siemens NX CAD called 'Through Curves' which does this but I am not sure if Fusion can do this?

Thanks,

Dalip

Re: Creating a surface

davebYYPCU — Thu, 25 Jan 2024 22:09:07 GMT

Surface > Create > Loft

select the curves.

Might help….

Re: Creating a surface

dsj013 — Thu, 25 Jan 2024 22:41:47 GMT

Hi,

Thanks for the response. I have attached a image of the two curve I am trying to create the surface between. Its hard to see but the Blue line is not in the same plane at the other line if that makes sense.

Re: Creating a surface

dsj013 — Thu, 25 Jan 2024 22:46:52 GMT

When I use loft it tried to do what I am trying to achieve but the surface don't nicely close and instead intersect.

Re: Creating a surface

jhackney1972 — Thu, 25 Jan 2024 23:29:27 GMT

Attach your model, not just a screen capture.

If you do not know how to attach your Fusion 360 model follow these easy steps. Open the model in Fusion 360, select the File menu, then Export and save as a F3D or F3Z file to your hard drive. Then use the Attachments section, of a forum post, to attach it.

Re: Creating a surface

dsj013 — Thu, 25 Jan 2024 23:32:25 GMT

Sorry I have attached the model.

Re: Creating a surface

davebYYPCU — Fri, 26 Jan 2024 02:40:32 GMT

You didn't say they were projected curves, that are not coincident joins.

The blue curve works as expected the purple curve is a series of short curves.

No timeline, can't fix it.

Might help....