topic Joint state using parametric conditional in Fusion Support Forum

Joint state using parametric conditional

o1grossman — Fri, 03 Oct 2025 20:14:39 GMT

I'm trying to flip between states of a revolute joint using a conditional in the parameters table. For some reason the joint doesn't respond when the parameter for the angle is changed using an "IF" statement. Any thoughts?

Re: Joint state using parametric conditional

davebYYPCU — Sat, 04 Oct 2025 00:04:58 GMT

Works for me, (after the fact) not sure how you were setting it up....

Might help...

Re: Joint state using parametric conditional

jhackney1972 — Sat, 04 Oct 2025 00:45:51 GMT

As @davebYYPCU has pointed out, you need to add the Parameter to the controlling Joint. It would also help your understanding of the IF statement if you add the "Conditional Test" to the statement, in this case "not equal to". Here is a link to the Fusion Parameters Reference Webpage.