topic Re: Defining rectangle corners with vertices or construction points in Fusion Support Forum

Defining rectangle corners with vertices or construction points

paulGJCBP — Sun, 17 Mar 2024 17:00:30 GMT

I want to create a cabinet with panels in a groove. I am trying to create a rectangle to extrude into a panel to fit into an existing groove. I want to use the corners of the groove cross section as two point defining the rectangle sketch. The plan was to extrude that rectangle down the length of the groove. I define the plane of the rectangle at the end of the groove cross section but instead of snapping to the vertices of the rectangular grove, the cursor remains free floating. I even tried creating construction points at the vertices, but they are not accessible when drawing in the sketch mode.

I could probably use the measurements of the grooves and the separation between the two grooved boards, but the idea is to use the existing components as reference points so I don't have to recalculate every thing.

Thanks!

I don't know if the attached project file will show the issue.

Re: Defining rectangle corners with vertices or construction points

davebYYPCU — Sun, 17 Mar 2024 17:47:12 GMT

Try Sketch > Project tools.

You need to bring existing external geometry, into the current sketch - to be able to snap to these projected articles. Sometimes they are purple, sometimes invisible.

Try Thin Extrude after stream lining the amount of sketching.

Might help….

Re: Defining rectangle corners with vertices or construction points

paulGJCBP — Sun, 17 Mar 2024 18:08:35 GMT

Thanks. Hope I don't appear too dense by I don't see the sketch>project tools menu item.

Re: Defining rectangle corners with vertices or construction points

g-andresen — Sun, 17 Mar 2024 18:15:29 GMT

Hi,

@paulGJCBP wrote:

Thanks. Hope I don't appear too dense by I don't see the sketch>project tools menu item.

active sketch mode > CREATE > PROJECT > project or shortcut P

günther

Re: Defining rectangle corners with vertices or construction points

paulGJCBP — Sun, 17 Mar 2024 19:06:22 GMT

Yes, I see that now.

1) Even though I now can see the projected vertices of the groove cross section, the rectangle tool does not snap to them - ignores them.

2) The top of the panel mates with the top grooved board and the bottom of the panel mates with the separate bottom grooved board. I need to snap to the vertices of grooves of these two separated boards. There is no common surface and doesn't project to a construction plane that includes the top and bottom.

See attached image

Re: Defining rectangle corners with vertices or construction points

jhackney1972 — Sun, 17 Mar 2024 19:55:11 GMT

See of this video helps. Model is attached.

(view in My Videos)

Re: Defining rectangle corners with vertices or construction points

jhackney1972 — Sun, 17 Mar 2024 21:04:40 GMT

Did my video answer your questions? If not, let me know, If so, please select Accept Solution on my post.