topic Re: sketch problem when emboss in Fusion Support Forum

sketch problem when emboss

h725mb — Wed, 26 Mar 2025 10:31:53 GMT

Hi everybody, I'm new here, I'd lik to ask a question:I've got a problem during embossing a sketch on a solid, Fusion tell me this error message

"impossible to emboss near some works - There are some features, voids or holes on the selected face in the target area that prevent the emboss"

Someone could know how can i resolve the problem?

Thanks to all!

Re: sketch problem when emboss

TheCADWhisperer — Wed, 26 Mar 2025 11:45:20 GMT

@h725mb

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

Re: sketch problem when emboss

jhackney1972 — Wed, 26 Mar 2025 16:04:17 GMT

If the sketch, to be Embossed, overlaps any cutout on the surface you are embossing to, it will fail. Maybe you can change the order of your timeline, Emboss first then do other operations. Please attach your mode.

Re: sketch problem when emboss

h725mb — Wed, 26 Mar 2025 16:37:56 GMT

Here it is the f3d file!

Thanks!

Re: sketch problem when emboss

jhackney1972 — Wed, 26 Mar 2025 19:52:07 GMT

The path of your third Sweep feature created a irregular model section, the one you were trying to Emboss to, so the Emboss would not finish. You must be sure the sketch length fits within the outside perimeter of the body. I have not idea what sections of the sketch you want to Emboss so I did just a few at random to show it works. Model is attached.

Re: sketch problem when emboss

h725mb — Thu, 27 Mar 2025 07:42:20 GMT

Thanks a lot from Italy 😉 I'll try to see tomorrow when I'll back home! I'm curious!

Re: sketch problem when emboss

h725mb — Fri, 28 Mar 2025 17:16:45 GMT

It's all ok! Thank you very much! I wouldn't have found the solution in my entire life! Thanks again!