topic Re: Struggling to Acheive my Intended Design in Fusion Support Forum

Struggling to Acheive my Intended Design

Latheboy — Tue, 02 Apr 2024 18:46:22 GMT

Hello,

I am trying to finalize what is intended to be a 3d adaptive machining project on the attached. I am confused as to how to correct "Extrude 1" in the timeline, as well as to achieve the shape I am seeking. The intention is to have the stair step shape with a 2" radius recess. Hoping someone can assist with the proper steps to accomplish this.

Thanks

Re: Struggling to Acheive my Intended Design

jhackney1972 — Tue, 02 Apr 2024 20:45:51 GMT

I have fixed your model's timeline but you will have to explain what the last 5 sketches in the timeline are all about. Model is attached.

Re: Struggling to Acheive my Intended Design

Latheboy — Tue, 02 Apr 2024 22:16:45 GMT

Thank you for fixing the error, I tried but couldn't figure out what the exact issue was or how to address it.

I don't know what the other sketches were, but I removed them. I suspect that I went about the cad drawing the wrong way. I am trying to get the step shape to be on a curve to match the contour behind it without the two outer corners.

Never did this before so I am only guessing.

Thanks,

Steve

Re: Struggling to Acheive my Intended Design

Latheboy — Wed, 03 Apr 2024 15:09:27 GMT

Hello,

I made some progress and the design appears to be what I am after, however, setup 2 has two elements on the manufacture side that I don't see on the design side as seen here. I don't want the two vertical elements in the center of the part and can't seem to resolve this. I have attached the updated file for review.

Thanks