topic Re: Decal moves after extrude on unrelated face in Fusion Support Forum

Decal moves after extrude on unrelated face

Scoox — Mon, 25 Dec 2017 22:27:31 GMT

Please see below screencast. The decal is initially nice and centered. After I cut a square hole in one of the sides of the component, the decal moves.

I've shared this project here: http://a360.co/2kTq419

Re: Decal moves after extrude on unrelated face

Scoox — Mon, 25 Dec 2017 22:30:01 GMT

And here is the screencast which, due to a bug in the forum, gets deleted from posts after the post is edited:

Re: Decal moves after extrude on unrelated face

Scoox — Tue, 23 Jan 2018 08:57:43 GMT

Bump

Re: Decal moves after extrude on unrelated face

paul.clauss — Thu, 25 Jan 2018 18:14:52 GMT

Hi @Scoox

Thanks for posting - my apologies for the delay in response! I had a look at this today and was unable to recreate the behavior with the decal moving in the file you attached earlier on - it does appear to be a different version than the file shown in your screencast. Would you mind sharing the file you recorded the screencast with me? I was also unable to recreate this issue in a new file.

We do have an internal ticket describing this behavior (FUS-12658) and your file may help us learn more about why this problem occurs. We appreciate your input!

Re: Decal moves after extrude on unrelated face

Scoox — Thu, 08 Feb 2018 13:10:07 GMT

Sorry too for taking this long to reply. I'm glad this issue was noticed elsewhere.

Regarding the file version I shared, I'm not sure what happened there. I've just tried to reproduce the issue using the same project and I was unable to. If this is an intermittent issue it maybe hard to track down. Anyway, I'll be sure to post back if I bump into this problem again.