topic How to copy and paste part of a sketch in Fusion Support Forum

How to copy and paste part of a sketch

RoboDLC — Wed, 24 Jan 2018 19:38:01 GMT

I wish to copy the geometry I defined at the top of this sketch to the exact same locations on the three other sides of the 15mm square. Is there a way to do this or do I need to re-create it on each edge?

thanks,

DLC

Re: How to copy and paste part of a sketch

kate.raskauskas — Wed, 24 Jan 2018 19:49:14 GMT

Hi @RoboDLC,

Absolutely! I'd recommend using either Sketch > Circular Pattern or Sketch > Rectangular pattern, depending on how you want the copies positioned. That way, any changes made to the original will be reflected in the copies. I'll post a screencast in a few minutes with a quick example.

Re: How to copy and paste part of a sketch

kate.raskauskas — Wed, 24 Jan 2018 20:02:32 GMT

Here's the quick example screencast:

Re: How to copy and paste part of a sketch

RoboDLC — Wed, 24 Jan 2018 22:29:07 GMT

Nice. Was there audio in this that I am not hearing or is it just silent?

Many thanks,

DLC

Re: How to copy and paste part of a sketch

kate.raskauskas — Thu, 25 Jan 2018 16:29:40 GMT

Nope, it was silent 🙂

Re: How to copy and paste part of a sketch

RoboDLC — Tue, 30 Jan 2018 23:39:12 GMT

Thanks for the help. Your example was pretty fast and I am not good enough to follow it all. The steps are partially faded out on the left and hard to follow. I need to watch more instructional videos.

Onward!

DLC