topic Re: [BUG] Sheet metal unfold with offset splines not working in Fusion Support Forum

[BUG] Sheet metal unfold with offset splines not working

TrippyLighting — Tue, 13 Feb 2018 06:09:14 GMT

I created a sketch with a "normal" spline tangential to a a little line segment and then I offset that spline/line.

I can create a Flange and unfold it from the original spline/line.

However, when I try the same with the offset version it returns an error:

Re: [BUG] Sheet metal unfold with offset splines not working

masa.minohara — Tue, 13 Feb 2018 08:03:10 GMT

Hi Peter,

I tested with a similar spline and line but was not able to reproduce the issue. However, I couldn't figure out why unfold fails in your design so I went ahead and logged the issue with the development. (FUS-38217) I'll post an update as soon as I have one.

Thank you for reporting the issue!