topic Sketch constraint bug in Fusion Support Forum

Sketch constraint bug

tkeding — Wed, 10 Apr 2024 08:31:34 GMT

Hello,

I just encountered a sketch issue: I have a fully constrained sketch which after adding some lines and dimensions has a weird issue of being able to drag a fully constrained circle center point (see picture). As the file is just a quick study, I just resolved the issue by deleting the circle, but it might be interesting to figure out the bug causing this?

attached the file

Greetings

Betreff: Sketch constraint bug

Birk.Marold — Wed, 10 Apr 2024 09:33:06 GMT

dont bother!
since the latest update sketching doesnt even snap to points of geometry anymore.

Its was always buggy since i started using it over 3 years ago and the mods here never cared about it and instead of fixing stuff, they make everything more buggy with every update.

Betreff: Sketch constraint bug

g-andresen — Wed, 10 Apr 2024 09:52:36 GMT

Hi,

@Birk.Marold wrote:

dont bother!
since the latest update sketching doesnt even snap to points of geometry anymore.

Its was always buggy since i started using it over 3 years ago and the mods here never cared about it and instead of fixing stuff, they make everything more buggy with every update.

As I don't know the behaviour, it would be helpful if you could show it in a screencast.

günther

Re: Sketch constraint bug

rohit.bapat — Wed, 10 Apr 2024 10:30:51 GMT

Hello @tkeding

I tried to reproduce the issue with attached file. I deleted one dimension (of 270 size) and re added it. I was able to drag curves even if they are shown fully constrained.

I have created a ticket for further investigation.