https://forums.autodesk.com/t5/fusion-support-forum/postprocessor-turning-edingcnc/m-p/8034450#M175324 <P>Hello,</P><P>I am trying to create a toolpath for Eding Lathe. It gives a fold that the turning toolpath is not supported.</P><P>Is there anybody that has make a new postprocessor?</P> Wed, 30 May 2018 07:32:37 GMT jjvanballegooijen6AZLL 2018-05-30T07:32:37Z https://forums.autodesk.com/t5/fusion-support-forum/postprocessor-turning-edingcnc/m-p/8034450#M175324 <P>Hello,</P><P>I am trying to create a toolpath for Eding Lathe. It gives a fold that the turning toolpath is not supported.</P><P>Is there anybody that has make a new postprocessor?</P> Wed, 30 May 2018 07:32:37 GMT https://forums.autodesk.com/t5/fusion-support-forum/postprocessor-turning-edingcnc/m-p/8034450#M175324 jjvanballegooijen6AZLL 2018-05-30T07:32:37Z https://forums.autodesk.com/t5/fusion-support-forum/postprocessor-turning-edingcnc/m-p/8034490#M175325 <P>Hi&nbsp;<a href="https://forums.autodesk.com/t5/user/viewprofilepage/user-id/4239450">@jjvanballegooijen6AZLL</a>,</P> <P>&nbsp;</P> <P>Thank you for posting! I'm not able to provide assistance with post customization but you can find some options in <A href="https://knowledge.autodesk.com/support/hsm/troubleshooting/caas/sfdcarticles/sfdcarticles/Request-for-post-processors-for-Fusion-360-or-HSM-product.html" target="_blank">this page</A>.</P> <P>&nbsp;</P> <P>Hopefully that helps!</P> Wed, 30 May 2018 07:53:46 GMT https://forums.autodesk.com/t5/fusion-support-forum/postprocessor-turning-edingcnc/m-p/8034490#M175325 masa.minohara 2018-05-30T07:53:46Z