topic TOOLPATH WRAP in Fusion Support Forum

TOOLPATH WRAP

Farzati.Scott — Sat, 16 Jun 2018 09:58:40 GMT

Ok, so I'm using a toolpath wrap around a cylinder to do a slot. The path appears to be correct. However when I go to simulate the initial move shows a collision with the stock? I tried to have the cylinder with origin in a vertical position as well as setting the Z to the cylinder with no luck. The tool is clear above the part, so what is happening???

Thanks,

Re: TOOLPATH WRAP

paul.clauss — Mon, 18 Jun 2018 15:54:08 GMT

Hi @Farzati.Scott

Thanks for posting! Sometimes I notice that Fusion shows a collision at the beginning of its ramping or entry move. If you'd like to share the file you are working with I'm happy to have a look and potentially log a ticket. I have seen the simulation show collisions on entry before - these can likely be ignored, just double check your entry heights.