Dimension to midpoint BUG

HughesTooling — Sat, 28 Jul 2018 10:07:36 GMT

Normally you can dimension to the midpoint of a line by holding the Shift button down. What I noticed is if you apply a midpoint constraint between 2 lines first you can no longer select the midpoint for a dimension using shift. The midpoint is still selectable with a point but the dimension tool does not see it.

Mark

Re: Dimension to midpoint BUG

saito.kh — Sun, 29 Jul 2018 00:51:35 GMT

Hi @HughesTooling,

Thank you for reporting this.

I recreated this behavior on my end with this update (R2.0.4343). I've logged a bug with our development team for the further investigation. (internal reference ID: FUS-42142). Once I hear back from the team, I will update this thread to share the information. I apologize for any inconveniences this may cause you - we appreciate you bringing this to our attention!

At this time I might create a point object at the location where midpoint was constrained and try to create a dimension.

If you have any questions, please let me know!

Thanks.

topic Re: Dimension to midpoint BUG in Fusion Support Forum

Dimension to midpoint BUG

Re: Dimension to midpoint BUG